Fwd: ☠ Buildbot (GNU pspp CI): debian-buster-amd64 - failed compile (failure) compile (failure) '/home/buildbot/pspp-buildbot/get_test_results.sh debian-buster-amd64-build' (failure) (master)

[Friedrich Beckmann]

Hi Ben,

the introduction of g_memdup2 breaks the compilation on debian buster because this was introduced in a later glib2 version.

https://discourse.gnome.org/t/port-your-module-from-g-memdup-to-g-memdup2-now/5538

Buster has glib 2.58.3 while we need now 2.67.3. Maybe we should note this in the minimum requirements. Also Debian bullseye has 2.66.8 and will probably fail to build.

Regards

Fritz

Anfang der weitergeleiteten Nachricht:

Von: buildbot@pspp.org
Datum: 9. Juli 2022 um 06:48:45 MESZ
An: friedrich.beckmann@gmx.de
Betreff: ☠ Buildbot (GNU pspp CI): debian-buster-amd64 - failed compile (failure) compile (failure) '/home/buildbot/pspp-buildbot/get_test_results.sh debian-buster-amd64-build' (failure) (master)



A failed build has been detected on builder debian-buster-amd64 while building GNU pspp CI.

Information:

• Build state: failed compile (failure) compile (failure) '/home/buildbot/pspp-buildbot/get_test_results.sh debian-buster-amd64-build' (failure)
• Revision: 93261332cde187e1392b6935234b2b1d8b9a1d51
• Worker: hsa-worker
• Build Reason: (unknown)
• Blamelist: Ben Pfaff

Steps:

• 0: worker_preparation ( success )
• 1: git ( success ) ( <stdio> )
• 2: compile ( failure ) ( <stdio> <warnings (115)> )
• 3: make check ( failure ) ( <stdio> )
• 4: Test Results ( failure ) ( <stdio> <testsuite.log> )
• 5: shell ( success ) ( <stdio> )
• 6: shell_1 ( success ) ( <stdio> )