qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Qemu-devel] [Qemu-ppc] qemu does not support PAPR


From: sonia verma
Subject: Re: [Qemu-devel] [Qemu-ppc] qemu does not support PAPR
Date: Thu, 5 Jun 2014 22:43:22 +0530

Hi Stuart.

Thanks for the information.I need to run libguestfs on powerpc ubuntu.How can i do that?

Are there any patches for the same.

On Jun 5, 2014 8:59 PM, "Stuart Yoder" <address@hidden> wrote:


> -----Original Message-----
> From: Alexander Graf [mailto:address@hidden]
> Sent: Thursday, June 05, 2014 2:59 AM
> To: sonia verma
> Cc: Paolo Bonzini; abhishek jain; address@hidden; qemu-devel; Yoder
> Stuart-B08248
> Subject: Re: [Qemu-ppc] qemu does not support PAPR
>
>
>
> > Am 05.06.2014 um 09:45 schrieb sonia verma <address@hidden>:
> >
> >
> > So what can be the solution for this?
>
> Please don't top post.
>
> You're running on QorIQ which is a Freescale chip. The pseries target
> only works on IBM PPC chips.
>
> The target you're looking for is ppce500:
>
>   $ qemu-system-ppc64 -M ppce500 -nographic -kernel uImage ...
>
> I don't know about the status of libvirt in your sdk version, but I'm
> sure Stuart does, so let's ask him ;).

libvirt is supported in Freescale SDK 1.4 in the Yocto-built rootfs, so I
would expect anything that uses libvirt interfaces to work there.  But, we
haven't specifically tested libguestfs.

However, it looks like you may not be using the SDK Yocto rootfs, but a
ubuntu rootfs.  In that case there may be a issue with the ubuntu libvirt.
There are some patches that we apply to libvirt that you will find only in the
Freescale SDK...you can find them if you look at the libvirt Yocto
recipe.

Stuart


reply via email to

[Prev in Thread] Current Thread [Next in Thread]