Re: [PATCH 3/3] Add support for TPM devices over I2C bus

[Ninad Palsule]

On 3/21/23 8:30 PM, Stefan Berger wrote:
> On 3/21/23 01:30, Ninad Palsule wrote:
> > Qemu already supports devices attached to ISA and sysbus. This drop adds
> > support for the I2C bus attached TPM devices. I2C model only supports
> > TPM2 protocol.
>
> > +
> > +/* Send data to TPM */
> > +static inline void tpm_tis_i2c_tpm_send(TPMStateI2C *i2cst)
> > +{
> > +    if ((i2cst->operation == OP_SEND) && (i2cst->offset > 1)) {
> > +        uint16_t tis_reg;
> > +        uint32_t data;
> > +        int      i;
> > +
> > +        tis_reg = tpm_tis_i2c_to_tis_reg(i2cst->data[0], &i2cst->size);
> > +
> > +        /* Index 0 is always a register */
> > +        for (i = 1; i < i2cst->offset; i++) {
> > +            data = (i2cst->data[i] & 0xff);
> > +            tpm_tis_write_data(&i2cst->state, tis_reg, data, 1);
> > +        }
>
>
> I think there should be tpm_tis_set_data_buffer function that you can 
> call rather than transferring the data byte-by-byte.
>
> Thanks for the series!
>
>   Stefan

I thought about it but the FIFO case performs multiple operations hence 
I did not want to change it. Currently there is no function to set data 
buffer in the common code.

Thanks for the review!

Ninad Palsule