[PATCH 15/22] hw/sd: ssi-sd: Support multiple block write

[Bin Meng]

From: Bin Meng <bin.meng@windriver.com>

For a multiple block write operation, each block begins with a multi
write start token. Unlike the SD mode that the multiple block write
ends when receiving a STOP_TRAN command (CMD12), a special stop tran
tocken is used to signal the card.

Emulating this by manually sending a CMD12 to the SD card core, to
bring it out of the receiving data state.

Signed-off-by: Bin Meng <bin.meng@windriver.com>
---

 hw/sd/ssi-sd.c | 26 ++++++++++++++++++++++++--
 1 file changed, 24 insertions(+), 2 deletions(-)

diff --git a/hw/sd/ssi-sd.c b/hw/sd/ssi-sd.c
index 21a96e91f0..6cf5d749c7 100644
--- a/hw/sd/ssi-sd.c
+++ b/hw/sd/ssi-sd.c
@@ -99,6 +99,8 @@ OBJECT_DECLARE_SIMPLE_TYPE(ssi_sd_state, SSI_SD)
 static uint32_t ssi_sd_transfer(SSIPeripheral *dev, uint32_t val)
 {
     ssi_sd_state *s = SSI_SD(dev);
+    SDRequest request;
+    uint8_t longresp[16];
 
     /* Special case: allow CMD12 (STOP TRANSMISSION) while reading data.  */
     if (s->mode == SSI_SD_DATA_READ && val == 0x4c) {
@@ -115,9 +117,31 @@ static uint32_t ssi_sd_transfer(SSIPeripheral *dev, 
uint32_t val)
             return SSI_DUMMY;
             break;
         case SSI_TOKEN_SINGLE:
+        case SSI_TOKEN_MULTI_WRITE:
             DPRINTF("Start write block\n");
             s->mode = SSI_SD_DATA_WRITE;
             return SSI_DUMMY;
+        case SSI_TOKEN_STOP_TRAN:
+            DPRINTF("Stop multiple write\n");
+
+            /* manually issue cmd12 to stop the transfer */
+            request.cmd = 12;
+            request.arg = 0;
+            s->arglen = sdbus_do_command(&s->sdbus, &request, longresp);
+            if (s->arglen <= 0) {
+                s->arglen = 1;
+                /* a zero value indicates the card is busy */
+                s->response[0] = 0;
+                DPRINTF("SD card busy\n");
+            } else {
+                s->arglen = 1;
+                /* a non-zero value indicates the card is ready */
+                s->response[0] = SSI_DUMMY;
+            }
+
+            s->mode = SSI_SD_RESPONSE;
+            s->response_pos = 0;
+            return SSI_DUMMY;
         }
 
         s->cmd = val & 0x3f;
@@ -126,8 +150,6 @@ static uint32_t ssi_sd_transfer(SSIPeripheral *dev, 
uint32_t val)
         return SSI_DUMMY;
     case SSI_SD_CMDARG:
         if (s->arglen == 4) {
-            SDRequest request;
-            uint8_t longresp[16];
             /* FIXME: Check CRC.  */
             request.cmd = s->cmd;
             request.arg = ldl_be_p(s->cmdarg);
-- 
2.25.1