[Texi2html-cvs] Changes to texi2html/Tests/nodes_texinfo_res/Two_002dcolumn-Tables.html

[Patrice Dumas]

Index: texi2html/Tests/nodes_texinfo_res/Two_002dcolumn-Tables.html
diff -u texi2html/Tests/nodes_texinfo_res/Two_002dcolumn-Tables.html:1.5 
texi2html/Tests/nodes_texinfo_res/Two_002dcolumn-Tables.html:1.6
--- texi2html/Tests/nodes_texinfo_res/Two_002dcolumn-Tables.html:1.5    Tue Aug 
 9 17:19:22 2005
+++ texi2html/Tests/nodes_texinfo_res/Two_002dcolumn-Tables.html        Tue Aug 
23 23:51:14 2005
@@ -101,7 +101,7 @@
 <p>Use the <code>@table</code> command to produce two-column tables.
 </p>
 <p>Write the <code>@table</code> command at the beginning of a line and follow
-it on the same line with an argument that is a Texinfo &quot;indicating&quot;
+it on the same line with an argument that is a Texinfo &ldquo;indicating&rdquo;
 command such as <code>@code</code>, <code>@samp</code>, <code>@var</code>, or
 <code>@kbd</code> (see section <a href="Indicating.html#SEC120">Indicating 
Definitions, Commands, etc.</a>).  Although these commands are usually
 followed by arguments in braces, in this case you use the command name
@@ -117,7 +117,7 @@
 <code>@table</code>.  <code>@asis</code> is a command that does nothing; if you
 use this command after <code>@table</code>, TeX and the Info formatting
 commands output the first column entries without added highlighting
-(&quot;as is&quot;).
+(&ldquo;as is&rdquo;).
 </p>
 <p>(The <code>@table</code> command may work with other commands besides those
 listed here.  However, you can only use commands that normally take