Re: problem configuring libtool

[Vivek Katakam]

Hi Ralf,
I got over the error after i removed the corrupt files of Makefile.in
and Configure.ac. that were present from the previous configuration.
I took a fresh dump and I this time i did not notice the above errors.

Thanks and Regards,
Vivek

On Sat, Jul 25, 2009 at 3:14 PM, Ralf Wildenhues<address@hidden> wrote:
> Hello Vivek,
>
> * Vivek Katakam wrote on Thu, Jul 23, 2009 at 11:00:06AM CEST:
>> I am trying configure ACE. I am getting the following error:
>> apps/JAWS2/JAWS/Makefile.am:20: The usual way to define `LIBTOOL' is
>> to add `AC_PROG_LIBTOOL'
>> apps/JAWS2/JAWS/Makefile.am:20: to `configure.ac' and run `aclocal'
>> and `autoconf' again.
>> apps/JAWS3/jaws3/Makefile.am:20: Libtool library used but `LIBTOOL' is 
>> undefined
>>
>> When i ran aclocal and then autoconf, i am getting the following error
>> after running autoconf:
>>
>> configure.ac:1: error: possibly undefined macro: dnl
>>       If this token and others are legitimate, please use m4_pattern_allow.
>>       See the Autoconf documentation.
>>
>> can someone please help what went wrong. The following are the
>> configurations on the SLES11 OS:
>> autoconf : 2.61
>> automake:  1.9.6
>> libtool : 2.2.6
>
> I'm not sure yet what is going on, maybe a quoting error or a
> nonstandard way to bootstrap this package.  Can you post a link to the
> source tarball or repo that you are trying to build?
>
> Cheers,
> Ralf
>