bug-make
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

How to install gmake and pkg-config?


From: nlsde
Subject: How to install gmake and pkg-config?
Date: Sun, 8 May 2005 11:54:54 +0800

bug-make,

I encountered a problem when I was trying to compile a gtk programm on HPUX 
11.0. 

I followed the instructions and have downloaded the following 
packages:'atk-1.9.0.tar','gtk+-2.6.0.tar','glib-2.6.0.tar','pango-1.6.0.tar',''pkgconfig-0.17.tar','make-3.80'.
 

First, I installed 'make-3.80' by using command './configure 
--prefix=/opt/gtk'. Then 'make','make install'.
Secondly, I tried to install 'pkgconfig-0.17' using the same command, but it 
went wrong when I run 'make' command, it displayed error informatino such as: 
<Bundled>cc:"glibconfig.h",line 30:error 1000: unexpected symbol:"int".
.
.
.
<Bundled>cc:"glib.h",line 767:error 1000: unexpected symbol:"*".
<Bundled>cc:error 2017:Cannot recover from earlier errors, terminating.

It seemed that I have failed to install the pkg-config, also I can't not find 
any GNU make or gmake in my computer. What should I do next?

IF I HAVE BEEN USING A WRONG WAY TO SOLVE THIS PROBLEM, PLEASE TELL ME HOW TO 
CORRECTLY RUN A GTK PROGRAMM ON HPUX.

Thank you very much and I am looking forward to hearing from you!

Best wishes,    

        
                                
nlsde
address@hidden
2005-05-08

reply via email to

[Prev in Thread] Current Thread [Next in Thread]