[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: How to build libtool from git sources properly?
From: |
Bob Friesenhahn |
Subject: |
Re: How to build libtool from git sources properly? |
Date: |
Wed, 18 May 2016 16:41:23 -0500 (CDT) |
User-agent: |
Alpine 2.20 (GSO 67 2015-01-07) |
On Wed, 18 May 2016, Igor Zhbanov wrote:
run `./bootstrap`
-mike
It doesn't work on a PC without git or without network connection
because it needs to clone gnulib (although there is no gnulib folder
in libtool-2.4.6.tar.gz. But this is probably another story.
This is very unfortunate. I am not sure if it would work if you
cloned gnulib on another computer and copied the gnulib folder into
place since it may still make subsequent git accesses.
The bootstrap requirements make it difficult to support or test on
targets which can not run git or don't have network access.
Bob
--
Bob Friesenhahn
address@hidden, http://www.simplesystems.org/users/bfriesen/
GraphicsMagick Maintainer, http://www.GraphicsMagick.org/