Hi there
Sometimes this happened to me as well, even though I am not using
TWOG, one way I found it work is by disconnect the power and reconnect
it again, try it, see if it works
Regards
Chen
------------------------------------------------------------------------
*From:* address@hidden
[mailto:address@hidden
*On Behalf Of *Mohit Mundhra
*Sent:* Tuesday, October 07, 2008 12:14 PM
*To:* address@hidden
*Subject:* [Paparazzi-devel] TWOG - no answer on '?'
when I try to upload the usb bootloader onto the TWOG board, it is
giving me this message.
Even when I tried to upload the code using the ISP flash mode, it is
giving 'no answer on '?' ' message. Is the board working fine? What
can be the probable problem. This is a new TWOG board which I got from
PPZUAV. I have checked the 3.3 and 5 V rail. The voltages are fine on
them.
ioctl set ok, status = 6
ioctl get ok, status = 6
ioctl get ok, status = 6
ioctl set ok, status = 4
ioctl get ok, status = 4
ioctl get ok, status = 4
ioctl set ok, status = 0
ioctl get ok, status = 0
no answer on '?'
make: *** [upload_bl] Error 4
--
Mohit Mundhra
--~--~---------~--~----~------------~-------~--~----~
Aurora Integrated Systems
-~----------~----~----~----~------~----~------~--~---
------------------------------------------------------------------------
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel