We have the lea 5 h. I've been using an std I cable and the autopilot as a power regulator. I saw the battery port on the gps but I thought that was more of a backup system. I thought that we would be able to configure the gps without the battery. If the gps is unplugged it loses itsbroken config. I'll try using a battery
On Aug 26, 2011 3:34 PM, "Prof. Dr.-Ing. Heinrich Warmers" <
address@hidden> wrote:
> Dear Joey,
> what kind of GPS module do you use?
> Same have only ram, and when the battery is bad (discharged) they lose
> the configuration.
> In our case power on the module for a few hours charge the battery.
>
> Regards
>
> Heinrich
>
> Joseph Wagster schrieb:
>
>> Hello,
>>
>> We somehow got the gps module to pick up satellites through u center.
>> However when we change the configuration and then go to configue
>> configue save current configuration it does not save after we cycle
>> the power. Also the tech support at u blocks told us there is an
>> acknowledge section and it does not light up has he says it would.
>> Other than the com port or the baud rate we know are right because we
>> receive the satellites, does anyone have any ideas about what we could
>> be doing wrong.
>>
>> Thank you very much,
>> Joey
>>
>> On Aug 24, 2011 9:50 PM, "Joseph Wagster" <
address@hidden >> <mailto:
address@hidden>> wrote:
>>
>>------------------------------------------------------------------------
>>
>>_______________________________________________
>>Paparazzi-devel mailing list
>>
address@hidden
>>
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel>>
>>