|
| From: | Marius Pfeffer |
| Subject: | Re: [Paparazzi-devel] stm32f407discovery, only PPM input?how to input PWM? |
| Date: | Sat, 20 Sep 2014 11:29:23 +0200 |
Hello
You can use a ppm encoder board ( http://wiki.paparazziuav.org/wiki/PPM_Encoder) which generates a ppm signal from the pwm output of the receiver.
There are lots of chinese versions on hobbyking, ebay, ablibaba e.g. available.
Which receiver are you using ? Maybe there is already a internal ppm signal. (without any output pin, but you can solder a connection).
Best regards
Marius Pfeffer
Dear,
I am now running paparazzi of rotorcraft on stm32f407discovery,the IMU is
drotek 10dof v2,and I get raw data from all the sensors and it works
well,but finally I found that the f4discovery only receives the PPM input on
pin PC9,and my RECEIVER only generates PWM,how can I control the
boards,thanks!
Any help would be appreciated!
--
View this message in context: http://lists.paparazziuav.org/stm32f407discovery-only-PPM-input-how-to-input-PWM-tp16164.html
Sent from the paparazzi-devel mailing list archive at Nabble.com.
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
| [Prev in Thread] | Current Thread | [Next in Thread] |