Re: [Paparazzi-devel] A problem getting started with an ARDrone 2

[Ori Pessach]

Were you able to fly successfully after calibrating the magnetometer? 

On Thu, Nov 27, 2014 at 2:49 AM, Thomas Wuensche <address@hidden> wrote:

I have the same problems with ardrone and considered missing
configuration of magnetometer before the flight as potential
reason. However did not yet analyze it further.

Regards, Thomas

Am 26.11.2014 um 22:40 schrieb address@hidden:
> When you say it flies fine using QGroundControl, do you mean with
> paparazzi or another flight controller?
>
> Do you have flight logs of the crash?
>
> Also, airframe files (etc) might provide more clues.
>
> Chris Gough
>
> On 27 Nov 2014, at 2:00 am, Ori Pessach <address@hidden
> <mailto:address@hidden>> wrote:
>
>> Well? Any suggestions?
>>
>> Specifically - is there a way to enable logging in the firmware
>> running on the UAV? Any way to know what "normal" telemetry should
>> look like, so I can begin to understand why paparazzi wants to roll
>> the vehicle to the right, even if I'm holding it level?
>>
>> I don't have a joystick attached to the laptop during the flight.
>> Could the system be using a default value for the joystick reading in
>> that case?
>>
>> In short - what's my next troubleshooting step?
>>
>> Thanks,
>>
>> Ori
>>
>> On Sun, Nov 23, 2014 at 9:57 AM, Ori Pessach <address@hidden
>> <mailto:address@hidden>> wrote:
>>
>>     Hi,
>>
>>     I've been trying to get this to work for a while, and I seem to
>>     have hit a wall. Or rather, the ground.
>>
>>     I modified the rotorcraft_basic plan to get started, rather than
>>     create a brand new flight plan. The waypoints show up in GCS in
>>     the correct location on the map, and I can upload and start the
>>     firmware just fine. I get GPS lock and the PFD updates when I move
>>     the drone around.
>>
>>     The problem is that immediately after taking off, the done rolls
>>     sharply to the right and slams into the ground. Not the ideal outcome.
>>
>>     What might be happening there, and how can I diagnose what the
>>     drone is trying to do? It flies fine using QGroundControl, mostly.
>>
>>     Thanks,
>>
>>     Ori
>>
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden <mailto:address@hidden>
>> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
> -- --
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
--
EMS Dr. Thomas Wuensche e.K.
Sonnenhang 3
85304 Ilmmuenster
HRA Neuburg a.d. Donau, HR-Nr. 70.106

Phone: +49-8441-490260
Fax  : +49-8441-81860
http://www.ems-wuensche.com

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel