Re: [Paparazzi-devel] Blank GCS with Lisa/S

[beryl.wicaksono]

Here the screen shot after the GCS starting.
<http://lists.paparazziuav.org/file/n16852/Screenshot%2520from%25202015-03-03%2520195312_zpsci8zdy0g.png>
 
Is there any something wrong?

How's the setup of the hardware? So I just connect BMP to Lisa/S via SWD
port (like flashing)?

Yes, I have setup the DX6i 's modulation to DSM2. 

Thank you,

Beryl


Garrosh wrote
> Hello Beryl,
> 
> First, I'd like to ask you to post the output of "dmesg | tail" just after 
> you've started your GCS. 
> 
> When talking to the Lisa via BMP, you have at least 2 options: through gdb
> or 
> through paparazzi. To simplify the diagnosing process, I'd recommend using
> gdb 
> to upload and run your code on the Lisa S, see here : 
> http://wiki.paparazziuav.org/wiki/DevGuide/JTAG-Debug
> 
> Next, you may try to run your code with paparazzi through your BMP, you
> can 
> look here for more information : 
> http://wiki.paparazziuav.org/wiki/Subsystem/telemetry
> 
> Your usbrf is running on DSM2, but your controller may not. Did you verify 
> that you set your controller too?
> 
> In the link about the telemetry, it also tells you about baudrate.
> 
> Good luck!
> 
> Sam
> On March 3, 2015 07:01:26 AM beryl.wicaksono wrote:
> _______________________________________________
> Paparazzi-devel mailing list

> Paparazzi-devel@

> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel





-----
Beryl Wicaksono
Electrical Engineering
Bandung Institute of Technology
--
View this message in context: 
http://lists.paparazziuav.org/Blank-GCS-with-Lisa-S-tp16839p16852.html
Sent from the paparazzi-devel mailing list archive at Nabble.com.