[PATCH v2 46/53] migration/rdma: Silence qemu_rdma_connect()

[Markus Armbruster]

Functions that use an Error **errp parameter to return errors should
not also report them to the user, because reporting is the caller's
job.  When the caller does, the error is reported twice.  When it
doesn't (because it recovered from the error), there is no error to
report, i.e. the report is bogus.

qemu_rdma_connect() violates this principle: it calls error_report()
and perror().  I elected not to investigate how callers handle the
error, i.e. precise impact is not known.

Clean this up: replace perror() by changing error_setg() to
error_setg_errno(), and drop error_report().  I believe the callers'
error reports suffice then.  If they don't, we need to convert to
Error instead.

Bonus: resolves a FIXME about problematic use of errno.

Signed-off-by: Markus Armbruster <armbru@redhat.com>
Reviewed-by: Li Zhijian <lizhijian@fujitsu.com>
---
 migration/rdma.c | 14 ++++----------
 1 file changed, 4 insertions(+), 10 deletions(-)

diff --git a/migration/rdma.c b/migration/rdma.c
index 5e21dfca53..b85d5e60cb 100644
--- a/migration/rdma.c
+++ b/migration/rdma.c
@@ -2591,8 +2591,8 @@ static int qemu_rdma_connect(RDMAContext *rdma, bool 
return_path,
 
     ret = rdma_connect(rdma->cm_id, &conn_param);
     if (ret < 0) {
-        perror("rdma_connect");
-        error_setg(errp, "RDMA ERROR: connecting to destination!");
+        error_setg_errno(errp, errno,
+                         "RDMA ERROR: connecting to destination!");
         goto err_rdma_source_connect;
     }
 
@@ -2601,21 +2601,15 @@ static int qemu_rdma_connect(RDMAContext *rdma, bool 
return_path,
     } else {
         ret = rdma_get_cm_event(rdma->channel, &cm_event);
         if (ret < 0) {
-            error_setg(errp, "RDMA ERROR: failed to get cm event");
+            error_setg_errno(errp, errno,
+                             "RDMA ERROR: failed to get cm event");
         }
     }
     if (ret < 0) {
-        /*
-         * FIXME perror() is wrong, because
-         * qemu_get_cm_event_timeout() can fail without setting errno.
-         * Will go away later in this series.
-         */
-        perror("rdma_get_cm_event after rdma_connect");
         goto err_rdma_source_connect;
     }
 
     if (cm_event->event != RDMA_CM_EVENT_ESTABLISHED) {
-        error_report("rdma_get_cm_event != EVENT_ESTABLISHED after 
rdma_connect");
         error_setg(errp, "RDMA ERROR: connecting to destination!");
         rdma_ack_cm_event(cm_event);
         goto err_rdma_source_connect;
-- 
2.41.0