Re: [avr-chat] Problem with motor control: Using ATmega32 + LS7290 + L298 stepper motor drivers.

[Erik Christiansen]

On 16.09.11 20:00, peruano4life wrote:
> 
> I agree that the atmega only does steps but i think i am doing the steps
> correctly or the motor i am using has some special properties built in that
> only allow for applied motions drivers and not third party
> 
> 
> i am trying to use applied motions HT23-597
> 
> data sheet
> http://www.applied-motion.com/sites/default/files/HT23-597_RevB.pdf
> 
> 
> thanks for any help
> 

This may be of most help:

http://www.catb.org/~esr/faqs/smart-questions.html#beprecise

Erik

-- 
It is the collective mailing list wisdom of decades that the person
asking for help is in general best off by stating 4 things:
What he aims to achieve; What he did; What the exact results were;
What he tried to correct them, and with what effects.
This gives helpers the best basis to work from.
                                       - Mario Vukelic, on ubuntu-users.