Re: [avr-chat] DAPA programming hardware options

[Joerg Wunsch]

"Colin O'Flynn" <address@hidden> wrote:

> Wait? you have a STK600? Why bother with all this?

Fully agreed.

If you simply turn over your STK600, you'll find the pin assignment
for the ISP connectors printed on the bottom side.  Make this match
the signal names in the Hackaday description.

And read the documents Colin gave you :), in particular mind the
sentence there:

"Note: If the other application has its own power supply, the VTARGET
jumper must be removed before connecting STK600 to the other
application. STK600 may be damaged if the VTARGET jumper is not
removed."

(Alternatively, you could pull the 5 V supply for your circuitry from
the STK600 itself.)

But of course, if you've got an STK600 already, it ships with a
minimalistic target board using an ATmega2560, so you could as well
start with that device rather than rolling your own hardware.  But
that's your decision.
-- 
cheers, J"org               .-.-.   --... ...--   -.. .  DL8DTL

http://www.sax.de/~joerg/                        NIC: JW11-RIPE
Never trust an operating system you don't have sources for. ;-)