[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [avr-gcc-list] ATMega32 fuse bit problem
From: |
Anton Erasmus |
Subject: |
Re: [avr-gcc-list] ATMega32 fuse bit problem |
Date: |
Mon, 12 Nov 2007 09:24:31 +0200 |
On 11 Nov 2007 at 10:59, Csroluxx wrote:
Date sent: Sun, 11 Nov 2007 10:59:51 -0800 (PST)
From: Csroluxx <address@hidden>
To: address@hidden
Subject: Re: [avr-gcc-list] ATMega32 fuse bit problem
>
>
> James Pascoe wrote:
> >
> > Hi All,
> >
> > Apologies for the following question which is very OT, but there is a
> > good chance you guys can help.
> >
> > I am using an ATMega32 and inadvertantly programmed the fuse bits wrong
> > :-( ... instead of setting
> > the fuse bits to use a 16 Mhz external crystal as the clock source, I
> > programmed the chip to use the low frequency
> > crystal oscillator setting. Of course now, I can not program the device
> > anymore.
> >
> > Does anybody know if there is any way (other than getting hold of a
> > 32.768 Khz crystal) that I can recover the device ?
> >
> > Many thanks for any suggestions,
> >
> > James
> >
> >
> > _______________________________________________
> > AVR-GCC-list mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/avr-gcc-list
> >
> >
> Hi you can use one from old digital clock (or new one)
> =)
You can also program via the JTAG pins, you do not need an external clock for
that.
The AVRDRAGON is quite cheap, which you can use to re-program the fuses.
Regards
Anton Erasmus
--
A J Erasmus