Re: [Bayonne-devel] bayonne-1.2.11 E1 can not hear prompt when using globalcall

[Michel Stam]

Hello Julien,

If I look at the configuration I use for Dialogic boards, I use ParameterFile=ctr4.prm and ParameterFile2=ctr4.prm (mind the caps on the parameters). That should give you EuroISDN.

Furthermore, I usually specify ISABusWidth=16-BIT. Shouldn't affect you there. I think its the .prm files.

Hope this helps,

Cheers.

Michel

Julien Chavanton wrote:

Using bayonne-1.2.11 in Europe with Globalcall driver I do not hear
anything when I play prompt, however when I restart using dialogic
drivers I can hear the prompt?


Dialogic.cfg

[Genload - All Boards]
LogFile=genload.log
BusType=SCBus
SCBusClockMaster=AUTOMATIC
SCBusClockMasterSource=AUTOMATIC
PCMEncoding=ALAW

[Genload - PCI ID 0] /* Dual T1/E1 PCI HD */
ParameterFile=spandti.prm
Parameterfile2=spandti.prm
ISDNProtocol=ctr4
ISDNProtocol2=ctr4


Bayonne.conf

[dialogic]
; in globalcall, we use "spans", "span", and "protocol"
; number of globalcall spans
spans = 2
; globalcall span protocol
protocol = P_ISDN

; number of potential voice resource cards in system
voice = 15

; number of potential digital cards in the system
digital = 2

; number of pri spans to support, effects digital handling.
pri = 2

; interval for balancing cpu load.
;delay = 10


_______________________________________________
Bayonne-devel mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/bayonne-devel
  

--

Michel Stam ing.

Software Development Engineer

address@hidden

Houtweg 29
1251 CS Laren
The Netherlands

t:	+31 (0)35 548 98 58
f:	+31 (0)35 531 65 61

www.tlogics.nl