RE: [Bayonne-devel] bayonne-1.2.11 E1 can not hear prompt when using globalcall

[Julien Chavanton]

Yes this was my problem!

 

Thanks

Julien

 

---

From: Michel Stam [mailto:address@hidden
Sent: December 14, 2004 9:48 AM
To: Julien Chavanton
Cc: address@hidden
Subject: Re: [Bayonne-devel] bayonne-1.2.11 E1 can not hear prompt when using globalcall

 

Hello Julien,

If I look at the configuration I use for Dialogic boards, I use ParameterFile=ctr4.prm and ParameterFile2=ctr4.prm (mind the caps on the parameters). That should give you EuroISDN.

Furthermore, I usually specify ISABusWidth=16-BIT. Shouldn't affect you there. I think its the .prm files.

Hope this helps,

Cheers.

Michel

Julien Chavanton wrote:

Using bayonne-1.2.11 in Europe with Globalcall driver I do not hear

anything when I play prompt, however when I restart using dialogic

drivers I can hear the prompt?

Dialogic.cfg

[Genload - All Boards]

LogFile=genload.log

BusType=SCBus

SCBusClockMaster=AUTOMATIC

SCBusClockMasterSource=AUTOMATIC

PCMEncoding=ALAW

[Genload - PCI ID 0] /* Dual T1/E1 PCI HD */

ParameterFile=spandti.prm

Parameterfile2=spandti.prm

ISDNProtocol=ctr4

ISDNProtocol2=ctr4

Bayonne.conf

[dialogic]

; in globalcall, we use "spans", "span", and "protocol"

; number of globalcall spans

spans = 2

; globalcall span protocol

protocol = P_ISDN

; number of potential voice resource cards in system

voice = 15

; number of potential digital cards in the system

digital = 2

; number of pri spans to support, effects digital handling.

pri = 2

; interval for balancing cpu load.

;delay = 10

_______________________________________________

Bayonne-devel mailing list

address@hidden

http://lists.gnu.org/mailman/listinfo/bayonne-devel

 

--

Michel Stam ing.

Software Development Engineer

address@hidden

Houtweg 29
1251 CS Laren
The Netherlands

t:	+31 (0)35 548 98 58
f:	+31 (0)35 531 65 61

www.tlogics.nl