[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: GRUB fails to boot Win98
From: |
Graham Smith |
Subject: |
RE: GRUB fails to boot Win98 |
Date: |
Thu, 23 May 2002 08:07:44 +0100 |
Okuji,
Further to my earlier message, now that I've had time to think about it.
Assuming that the drive number and offset in the message are swapped it
would appear that when chainloading Win98 from GRUB installed on the hard
disk it is attempting to read sector 0x1a0b9a4 from (hd0). Interestingly
this is the exact offset of the first sector of partition (hd1,4) where
stage2 is installed and this offset is off the end of the smaller (hd0).
I have now also checked that the behaviour is the same when stage1 is
installed in (hd0) and booted directly as when it is installed in (hd1,4)
and chainloaded by LILO (which is what I had tested last night).
regards
Graham
P.S. I noted that the version of GRUB I downloaded from CVS now reports
itself as 0.93.