Re: oskit-stomach hd0s4: No such device or address

[Shakthi Kannan]

Hi,

Thanks for your replies Alfred M. Szmidt and Gianluca
Guida:

--- Gianluca Guida <glguida@gmail.com> wrote:
> The problem you encountered may be due to the fact
> that you're not
> using the latest tree, that you can find at
> http://wazzabbanda.homelinux.org/ . 

Thanks. I tried the recent
tempura-stomach--20050625.tar.bz2 and it booted! 

I find the console response to be much faster than
gnumach. Have you given lot of printfs during the boot
code? The startup bootlog sequence on the T41:

-----

GNUmach 1.3
AT386 boot: physical memory from 0x0 to 0x1ff60000
GNUmach 1.3
AT386 boot: physical memory from 0x0 to 0x1ff60000
pcibus_setup(1):        mode 1 addr port (0x0cf8) is
0x8000f904
pcibus_setup(1a):       mode1res=0x80000000 (0x80000000)
pcibus_check:   device 0 is there (id=33408086)
Prova 0                 SUBALLOCATING 21d20000 -> 21d40000
BIOS mapped to 0x21d20000
                        SUBALLOCATING 21d40000 -> 21d41000
                        SUBALLOCATING 21d41000 -> 21d42000
                        SUBALLOCATING 21d42000 -> 21d43000
init.c:142:
pcibios_init : OSKit PCI BIOS revision 1.0
PCI: Probing PCI hardware
init.c:160:
init.c:164:
scsi : 0 hosts.
scsi : detected total.
Dummy isa_bus component initialized.
PCI_IDE: unknown IDE controller on PCI bus 00 device
f9, VID=8086, DID=24ca
PCI_IDE: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x1860-0x1867, BIOS settings:
hda:DMA, hdb:pio
    ide1: BM-DMA at 0x1868-0x186f, BIOS settings:
hdc:DMA, hdd:pio
hd0: C/H/S=0/0/0 from BIOS ignored
hda: HTS548040M9AT00, ATA DISK drive
hdc: UJDA755zDVD/CDRW, ATAPI CDROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: HTS548040M9AT00, 34728MB w/7877kB Cache,
CHS=4427/255/63
hdc: ATAPI 24X DVD-ROM CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.11
Partition check:
 hda: hda1 hda2 hda3 hda4
PCI bridge found: PCI0:1:0
PCI bridge found: PCI0:30:0
NCR53c406a: no available ports found
vm_page_grab: no dma anymoremem_free: hash search
failed (0)!
vm_page_grab: no dma anymoremem_free: hash search
failed (0)!
vm_page_grab: no dma anymorevm_page_grab: no dma
anymoreeata_dma: can't allocate enough memory to probe
for hosts !
oskitcom/objs/mach_osenv_ioport.c:71: ioport_avail:
bad port range [0x10c88-0x10c91]
scsi: <fdomain> Detection failed (no card)
                        SUBALLOCATING 21df2000 -> 21df3000
                        SUBALLOCATING 21df3000 -> 21df4000
...
...
21e2f000
                        SUBALLOCATING 21e2f000 -> 2

----

It probes for floppy and spends lot of time there. Can
I disable the floppy detection? 

Thanks again,

K Shakthi

------------------------------------------------------------
Shakthi Kannan, MS
Software Engineer, Specsoft (Hexaware Technologies)
[E]: shaks@shakthimaan.com           [M]: (91) 98407-87007
[W]: http://www.shakthimaan.com      [L]: Chennai, India
------------------------------------------------------------

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com