Re: Problem running libtool 1.5 tests

[William Aiken]

Ralf,

libtool --version outputs:
ltmain.sh (GNU libtool) 1.5 (1.1220 2003/04/05 19:32:58)
...

so I am running the older 1.5 version.

This is the demo-make.test that is run after the demo-nopic.test

I used your gmake command below and get the same result, with a lot
intermediate output.

I will download,build,install newer m4 and libtool and try again.

Thanks for your help!

Bill



Ralf Wildenhues wrote On 08/29/07 15:10,:
> Hello Bill,
> 
> * William Aiken wrote on Wed, Aug 29, 2007 at 08:34:43PM CEST:
> 
>> I am trying to build libtool-1.5 on a Solaris 10 x64 (AMD) system
>>using gmake and Sun Studio 12. I downloaded, built and installed m4
>>(m4-1.4.4) and autoconf (2.60) before building libtool.
> 
> 
> Is that really libtool-1.5 and not libtool-1.5.24?  Because the former
> is rather old, more than four years (and I think the quote test has seen
> a related bugfix since).  Also, you should be using a newer m4, as 1.4.5
> fixes a rather nasty bug that shows in some Autoconf-generated configure
> scripts.
> 
> 
>>make runs without error messages.
>>make check fails demo-make.test and quote.test and outputs this at the end:
>>====================================
>>2 of 104 tests failed
>>(1 tests were not run)
> 
> 
> Thanks.  Is that the demo-make.test that is run after demo-nopic.test?
> If yes, then please rerun verbosely like this:
> 
>   gmake check VERBOSE=yes TESTS="demo-nopic.test demo-make.test quote.test"
> 
> and post the output.
> 
> Cheers,
> Ralf


-- 
William Aiken          Sun Microsystems, Inc.
Phone: 781.442.3312    ISV Engineering
FAX: 781.442.1520      One Network Drive UBUR01-204
                       Burlington, Massachusetts 01803