>2TB volume boot problem

[Carlos Knowlton]

Hi,

I've got a 3Ware 9500 12 Harware RAID controller that is full of 25GB 
S-ATA drives (total storage = 2.75TB).  To my 64bit FC3 box, this looks 
like a single huge SCSI disk (/dev/sda).  At first there was no way to 
partition this huge beast, but then [cue fanfare] I found parted!!  
needless to say, this worked well by using GPT labels (good job 
parted-guys!).  However, grub doesn't recognize GPT. 

So here's my question:  Does anyone know a way to boot from huge volumes 
(where "huge" =  >2TB)?   even if it doesn't involve grub, or GPT, I'm 
open to suggestions.  Anybody?


Thanks!
Carlos Knowlton