Re: [Discuss-gnuradio] Viewing square wave in usrp_oscope

[sudhindra aithal kota]

Hi,
 In my mail I have mentioned that I did try with
frequencies greater than 100Khz. But the behaviour was
the same as I had originally reported. 

Regards
Sudhindra

--- Lamar Owen <address@hidden> wrote:

> On Wednesday 07 December 2005 13:16, sudhindra
> aithal kota wrote:
> > Hi,
> >  I am still stuck with this problem.Can anyone
> please
> > tell me how to solve this?
> 
> Eric Blossom answered the question originally on
> 11/15; did you receive his 
> reply?
> 
> In a nutshell, the USRP Basic RX input transformer
> is only good down to 
> 100kHz; either use a higher frequency, or you will
> need to build your own 
> lower-frequency capable daughterboard.
> 
> As far as viewing square waves, I have verified,
> using quality cables and an 
> HP signal generator, that the USRP Basic RX and the
> usrp_oscope can indeed 
> display square waves at 500kHz, 1MHz, and 2MHz.
> -- 
> Lamar Owen
> Director of Information Technology
> Pisgah Astronomical Research Institute
> 1 PARI Drive
> Rosman, NC  28772
> (828)862-5554
> www.pari.edu
> 
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
>
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
> 



                
__________________________________________________________ 
Yahoo! India Matrimony: Find your partner now. Go to http://yahoo.shaadi.com