Re: [Discuss-gnuradio] Simultaneous TX/RX Sample Code for RFX (FLEX) 400

[Martin Dvh]

Matt Ettus wrote:
>>>Although I am aware that the signal will need to be attenuated severely, I
>>>am unsure what the RF front end of the RFX-400 is spec'd for.  With a 20 dBm
>>>signal at the TX, I am planning to use anywhere from 40 to 60 dB of
>>>attenuation.  I believe this will give me a -20 to -40 dBm signal at RX2. 
>>>This should be acceptable, right?  Thanks again for your help, it is much
>>>appreciated.
> 
> 
> There is enough leakage between the TX and RX side that you won't need
> to connect them at all.  Just put a dummy load on the TX side.  The
> TX/RX switch has about 35 dB of isolation.  You may get some extra
> isolation by setting the RX input to RX2 and putting another dummy load
> there.
> 
> You can also lower the TX power.
I thought the TX power allways had to be at maximum for the RFX boards.

greetings,
Martin
> 
> Matt
> 
> 
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>