Re: [Discuss-gnuradio] How to Repair a flex2400?

[Matt Ettus]

hanwen wrote:
>
> Hi, everyone.
>
> I've got a flex2400 damaged by filling signal directly into TX/RX
> though a cable. Now the borad can not either receive nor transmit. It
> seems that the flow graph always get halted.
> What part would be possible broken?
> Can it be repaired? And what should I do to make it work again?
>
> I've see the block diagram at
> http://www.pattoncentral.org/gnuradio/diagram/, but still not quite
> sure where the problem is.
>

If it neither receives nor transmits then you did quite a bit of
damage.  The TX and RX do not really share any components, so you
probably have more than one damaged.  It would be very difficult to repair.

Matt