Re: [Discuss-gnuradio] OpenBTS issue/help needed

[gohar anwar]

Thanks for your reply Davek,
In openbts/tests its written in README.test that

"Tests that can be built and run.

L1 Software Loopback (no USRP)

This test exercises L1 components for bidirectional channels.  It uses two executables: TRXManager/LoopbackTest and TRXManager/TRXSimulator.....

also

Beacon test
.....
This test uses the tests/BeaconTest and the Transceiver/runTransceiver binaries...."
There are only .cpp files with these names.
How to build these binaries/executables?
Make command does not perform this task.

Thanks
Gohar Anwar

---

From: davek <address@hidden>
To: Gohar <address@hidden>
Cc: "address@hidden" <address@hidden>
Sent: Friday, March 13, 2009 12:57:04 AM
Subject: Re: [Discuss-gnuradio] OpenBTS issue/help needed

the following excutables are in the openbts folder you svn'ed after
you do a make. they are not copied to the dist with make install, not
sure why, but they work...
openbts/apps/OpenBTS800
openbts/apps/OpenBTS900
openbts/Transciever/transciever

On Thu, Mar 12, 2009 at 3:41 PM, Gohar <address@hidden> wrote:
>
>
> Hi,
> I have installed  the OpenBTS by following the instructions on the page below:
>
> http://www.gnuradio.org/trac/wiki/OpenBTS/BuildingAndRunning
>
> Apparently there were no errors in all the process (ie: ./bootstrap, ./configure, make, make install)
> But i can only see Asterisk folder in /usr/local/share/OpenBTS.
> I want to run the tests like "loopbackTest.cpp" and "BeaconTest.cpp" etc.
>
> How to compile and run these tests? Which commands should i execute in terminal to run these .cpp files?
> I am on Ubuntu 8.10 with the latest trunk of GnuRadio.
>
>
> Best regards
> Gohar Anwar
>
>
>
>
>
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>