[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Scanning whole spectrum using TVRX
From: |
Vassily Gavrilyak |
Subject: |
Re: [Discuss-gnuradio] Scanning whole spectrum using TVRX |
Date: |
Wed, 7 Apr 2010 16:38:30 +0300 |
Probably this could help you:
http://www.mail-archive.com/address@hidden/msg16469.html
On Tue, Apr 6, 2010 at 4:56 PM, Anand Padmanabha Iyer
<address@hidden> wrote:
> Dear All,
> I have a TVRX board, and am trying to do some experiments with it. My
> requirement is to scan the entire spectrum (50MHz - 860MHz), and dump the
> samples for processing using MATLAB. At a time, I am sensing 250KHz of
> spectrum (decimation 256), and I am collecting 10,000 samples (40 ms sensing
> time).
> My initial take was to call usrp_rx_cfile.py multiple times, each time
> passing in a different frequency. However, this approach takes around 15
> minutes to scan the entire range (I assume it is due to the overheads). Is
> there any way I could make this faster?
> Regards,
> Anand
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>