Re: [Discuss-gnuradio] Unknown dboard-id

[Josh Blum]

Mr ninja,

The dbsrx is not yet supported under UHD. That is why dboard id 0x0002 
is not recognized. Our daughterboard engineer is working on it this very 
day; though I cannot make promises as to its release.

Regardless, if you intend to use the dbsrx with a usrp2, it will require 
the clock modification: 
http://gnuradio.org/redmine/wiki/gnuradio/USRP2DBSRXModification

When the dbsrx uhd support is out, we will have uhd-based instructions 
for the modification as well.

-Josh

On 08/04/2010 04:28 AM, Ninja wrote:
> I tested the usrp2 using uhd_usrp_probe, why is there a warning about unknown 
> dboard-id or dboard-id combination and Unknown value for RX Subdev and TX 
> Subdev (antenna?)?is there some miss when I assembled the device?or it's needed 
> to configure through software?
>
>
> address@hidden host]# /usr/local/bin/uhd_usrp_probe
> Current recv sock buff size: 50000000 bytes
> Current send sock buff size: 50000000 bytes
> Warning: unknown dboard-id or dboard-id combination: unknown (0x0002)
>      ->  defaulting to the unknown board type
> Warning: unknown dboard-id or dboard-id combination: unknown (0xffff)
>      ->  defaulting to the unknown board type
> Using: Unknown - unknown (0x0002)
> Using: Unknown - unknown (0xffff)
> RX samples per packet: 362
> TX samples per packet: 363
> Recv pirate num frames: 33967
>    _____________________________________________________
>   /
> |       Device: usrp2 device
> |     _____________________________________________________
> |    /
> |   |       Mboard: usrp2 mboard0 - rev 4:0
> |   |   mac-addr: 00:50:c2:85:37:ea
> |   |   ip-addr: 255.255.255.255
> |   |     _____________________________________________________
> |   |    /
> |   |   |       RX DSP: usrp2 ddc0
> |   |   |   Codec Rate: 100.000000 Msps
> |   |     _____________________________________________________
> |   |    /
> |   |   |       TX DSP: usrp2 duc0
> |   |   |   Codec Rate: 100.000000 Msps
> |   |     _____________________________________________________
> |   |    /
> |   |   |       RX Dboard: usrp2 dboard (rx unit)
> |   |   |     _____________________________________________________
> |   |   |    /
> |   |   |   |       RX Subdev: Unknown - unknown (0x0002)
> |   |   |   |   Antennas:
> |   |   |   |   Freq range: 0.000 to 0.000 Mhz
> |   |   |   |   Gain Elements: None
> |   |   |   |   Connection Type: 6
> |   |   |   |   Uses LO offset: No
> |   |     _____________________________________________________
> |   |    /
> |   |   |       TX Dboard: usrp2 dboard (tx unit)
> |   |   |     _____________________________________________________
> |   |   |    /
> |   |   |   |       TX Subdev: Unknown - unknown (0xffff)
> |   |   |   |   Antennas:
> |   |   |   |   Freq range: 0.000 to 0.000 Mhz
> |   |   |   |   Gain Elements: None
> |   |   |   |   Connection Type: 6
> |   |   |   |   Uses LO offset: No
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio