[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] DBSRX2 not recognized
From: |
Prachi Parihar |
Subject: |
[Discuss-gnuradio] DBSRX2 not recognized |
Date: |
Fri, 8 Jul 2011 13:57:58 -0400 |
Hello, I'm trying to use a recently purchased DBSRX2 + USRP1 combination. Although the board shows some signs of life, it's difficult to make sense of the fft spectrum. In investigating, I found that the daughterboard id does not seem to be correct. In particular, the gnuradio software reports dbid = 18 rather than the expected 2 or possibly 13 (all numbers decimal).
This result does not depend on the particular module I run. Below I show the simplest example (usrp_print_db.py). Please see the source and result below. Any suggestions would be greatly appreciated.
Sincerely,
Prachi Parihar
address@hidden:~$ python usrp_print_db.py
Warning: Treating daughterboard with invalid EEPROM contents as if it were a "Basic Rx."
Warning: This is almost certainly wrong... Use appropriate burn-*-eeprom utility.
Daughterboard Id: 18
RX d'board A: Unknown (0x0012)
*****************************
#!/usr/bin/env python
from gnuradio import gr
from gnuradio import usrp
from usrpm import usrp_dbid
u_source = usrp.source_c()
subdev = usrp.selected_subdev(u_source, (0,0))
print "Daughterboard Id:", u_source.daughterboard_id(0)
print "RX d'board %s" % (subdev.side_and_name(),)
- [Discuss-gnuradio] DBSRX2 not recognized,
Prachi Parihar <=