[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] GUNRadio+UHD installation on USRP E200
From: |
Nick Foster |
Subject: |
Re: [Discuss-gnuradio] GUNRadio+UHD installation on USRP E200 |
Date: |
Fri, 08 Jul 2011 14:14:19 -0700 |
On Fri, 2011-07-08 at 17:00 -0400, Yan Nie wrote:
> Dear all,
>
> I installed GNURadio+UHD on USRP E200 in Ubuntu 10.10 system by using the
> build-gnuradio script Marcus offered. After installation successfully
> completely, using uhd_find_devices gave the result:
> --------------------------------------------------
> -- UHD Device 0
> --------------------------------------------------
> Device Address:
> type: usrp2
> addr: 192.168.10.2
> name:
> serial:
>
> However, the result of uhd_usrp_probe leads to the net burner to allow the
> firmware build is the compatible with the host code build:
> Error: RuntimeError:
> Please update the firmware and FPGA images for your device.
> See the application notes for USRP2/N-Series for instructions.
> Expected protocol compatibility number 10, but got 9:
> The firmware build is not compatible with the host code build.
>
> Then I tried: ./usrp_n2xx_net_burner.py --addr=192.168.10.2
> --fw=/usr/local/share/uhd/images/usrp_n200_fw.bin to load the firmware, which
> gave the success result:
> USRP-N2XX found.
> Flash size: 4194304
> Sector size: 65536
>
> Begin firmware write: this should take about 1 second...
> Erasing 31744 bytes at 3145728
> Writing image
> Verifying data
> Read back 16383 bytes
> Success.
> Time elapsed: 1.245118 seconds
>
> Then loading the FPGA image in: ./usrp_n2xx_net_burner.py --addr=192.168.10.2
> --fpga=/usr/local/share/uhd/images/usrp_n200_fpga.bin, which also gave the
> success result:
> USRP-N2XX found.
> Flash size: 4194304
> Sector size: 65536
>
> Begin FPGA write: this should take about 1 minute...
> Erasing 1572864 bytes at 1572864
> Writing image
> Verifying data
> Read back 893184 bytes
> Success.
> Time elapsed: 43.030194 seconds
>
> After finishing the FPGA image and firmware loading, uhd_usrp_probe gave the
> same result as before. What could be the reason here? What is done
> incorrectly?
>
Did you try rebooting the N200?
--n
> Really appreciate your help!
>
> Thanks,
> Yan
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio