Re: [Discuss-gnuradio] uhd_find_devices issue

[Karan Talasila]

Marcus and Sam,
                          I brought a working ethernet cable and connected it from my laptop to the switch.I changed my network manager settings to use only static ip by modifying /etc/network/interfaces file. I still can't get uhd_find_devices script nor uhd_usrp_probe script. It still says uhd device not found. My usrp shows D and F Led's glowing. so i think that means firmware is loaded. what could be the problem? should i go ahead and reinstall it?

On Sat, Dec 29, 2012 at 1:27 AM, Sam mite <address@hidden> wrote:

If you are using a gigabit switch i.e your LAPTOP/PC is connected to gigabit switch and USRP is connected to gigabit switch then there should not be any problem. If you don't fine an extra cable, you can test Ethernet cable by connecting a PC/router and pinging it. Please see following links for your question on netmanager and dhcp:

http://askubuntu.com/questions/21654/how-to-temporarily-turn-off-networkmanager-from-the-command-line
http://www.ubuntugeek.com/change-ubuntu-system-from-dhcp-to-a-static-ip-address.html

Hope it helps.

>>>>Hi Marcus,
          
 >>>>                I have not changed the fpga firmware. I used the build-gnuradio script to install gnuradio. I am not finding another ethernet cable in the lab. I will check that and let you know in some hours.

>>>>My ethernet card in laptop is rtl 8101e. I checked that it is capable of only 100 Mbps. But here i am using a gigabit switch, so it shouldn't be a problem right. How should i check if my ethernet port is managed by >>>>netmanager with dhcp support? In my network connections it says auto eth0 for ethernet

>>>>--
>>>>Regards
>>>>Karan Talasila

--

Best Regards,

Sam

_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

-- 
Regards
Karan Talasila