[Ltib] Where does LTIB find /opt/freescale/pkgs as where to look for source/patch files?

[Peter Barada]

I'm trying to figure out where in LTIB it decides to use /opt/freescale/pkgs for the place to find source and patches?  I know about %ldir in .ltibrc, and pfx in the spec file, but even after changing those, it still looks in /opt/freescale/pkgs.

Where does LTIB get the information from?  Is it hard-coded in one of the utilities and is all but impossible to change?

-- 
Peter Barada // senior software engineer
 
LOGIC // embedded product solutions
411 Washington Ave. N. Suite 400
Minneapolis, MN 55401
M // 617.513.5874
 
address@hidden
www.logicpd.com

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / 

This message (including any attachments) contains confidential
information intended for a specific individual and purpose, and is
protected by law. If you are not the intended recipient, you should
delete this message and are hereby notified that any disclosure,
copying, or distribution of this message, or the taking of any action
based on it, is strictly prohibited.