Re: [Ltib] Ltib - How to make the MAC address in EEPROM works with kernel 2.6.34 just like kernel 2.6.27?

[Mike RA9FTM]

Hi, Henry

They also removed writing MAC adress, SDRAM memory configuration information, board hardware id to the EEPROM in the latest S1L version (CDL library v2 at the phytec ftp).

My question is, how u-boot will know what SDRAM memory is installed on the board?

--
73! Mike RA9FTM

2010/7/6 Li Yuan-Lung <henry.li@climax.com.tw>

Yes,

Sorry to forget tell you that it is LPC3250 platform.

Henry

2010/7/6 Mike RA9FTM <address@hidden>

Hi

Is your message about lpc3250? 

--
73! Mike RA9FTM

2010/7/6 Li Yuan-Lung <henry.li@climax.com.tw>

Dear NXP guys,

As a new issue, I create a new topic for this problem.

I have knew the facts as below:

1. The MAC address was read from EEPROM in kernel 2.6.27. 

2. The MAC address was passed by u-boot through kernel parameter in kernel 2.6.34. 

Below is my question:

1) Why the mechanism chaged? Is there any consideration or limitation to make kernel 2.6.34 with EEPROM?

2) Could I make the mechanism in 2.6.34 become the same with kernel 2.6.27? How?

Henry

_______________________________________________
LTIB home page: http://ltib.org

Ltib mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/ltib

--
Best Regards,

Henry Li
SW Engineer of Climax Co.
TEL: +886-2-2794-0001 ext.231
FAX: +886-2-2792-6618