[Octave-bug-tracker] [bug #41067] "run-octave --force-gui" octave exited with signal 11

[Kai Torben Ohlhus]

Follow-up Comment #1, bug #41067 (project octave):

Hello Mike Sander,

to get all dependencies for the current development version, I use this
command for Ubuntu 13.10:

sudo apt-get install 
  autoconf 
  automake 
  bison 
  doxygen 
  epstool 
  flex 
  freeglut3 
  freeglut3-dev 
  gcc 
  g++ 
  gfortran 
  glpk 
  gnuplot 
  gperf 
  graphviz 
  mercurial 
  libarpack2 
  libarpack2-dev 
  libblas3gf 
  libblas-dev 
  libcurl4-openssl-dev 
  libfftw3-3 
  libfftw3-dev 
  libfltk1.3 
  libfltk1.3-dev 
  libfontconfig1 
  libfontconfig1-dev 
  libfreetype6 
  libfreetype6-dev 
  libgl2ps-dev 
  libgraphicsmagick++1-dev 
  libhdf5-serial-dev 
  liblapack-dev 
  liblapack3gf 
  libpcre3 
  libpcre3-dev 
  libqhull5 
  libqhull-dev 
  libqscintilla2-dev 
  libqt4-dev 
  libqrupdate1 
  libqrupdate-dev 
  libreadline6 
  libreadline6-dev 
  libsuitesparse-dev 
  libtool 
  llvm 
  openjdk-7-jdk 
  openjdk-7-jre 
  pkg-config 
  transfig 
  zlibc 
  zlib1g 
  zlib1g-dev

For the configure script it should not be necessary to explicitly say
--with-opengl. Can you check afterwards, if you still cannot start octave?
./run_octave should work fine hopefully.

    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/bugs/?41067>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/