Re: dev (gui) build does not start on kubuntu 13.04

[Torsten]

On 19.08.2013 00:45, Kirill Fuior wrote:
> On 19.08.13 01:11, Daniel J Sebald wrote:
>>
>>
>>> If I add all the subdirectories of octave/scripts/ directory (btw, is
>>> there any way to do it in a single command?),
>>> it answers on any command something like this:
>>>
>>> error: unable to open /usr/local/share/octave/3.7.5/etc/macros.texi for
>>> reading
>>> error: called from:
>>> error: /home/amateur/octave/scripts/help/__makeinfo__.m at line 100,
>>> column 5
>>> error: /home/amateur/octave/scripts/help/print_usage.m at line 128,
>>> column 18
>>> error: /home/amateur/octave/scripts/help/print_usage.m at line 59,
>>> column 28
>>> error: /home/amateur/octave/scripts/plot/plot.m at line 206, column 5
>>>
>>> there is no /usr/local/share/octave/ folder, even if I do make install.
>>
>> I looked back at your build description and you didn't do an install.
>> I'm not sure, but I think one needs to be a superuser to install
>> Octave, so you may have not installed properly.  Without an install,
>> you need to use "run-octave" to properly set up the environment.  Are
>> you doing something like this?
>>
>> ~/octave/run-octave --no-gui
>>
>> ?
>>
>> Dan
> 
> Well,
> 
> ~/octave/run-octave --no-gui seems to work fine: it starts with correct
> path, simple plot example is also works.
> but ./run-octave still does not work.
> 
> The same for installed dev binaries: /usr/local/bin/octave-3.7.5 does
> not work, but works with --no-gui.
> 
> Kirill.

Are there any warnings in the config.log created by configure.

Torsten