[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Booz Upload misery

From: antoine drouin
Subject: Re: [Paparazzi-devel] Booz Upload misery
Date: Sat, 22 May 2010 16:11:05 +0200

Hello Eric

I just checked and the HITL_USB airframe also uses IAP ( aka the usb
bootloader ) for flashing, so it shouldn't have cleared your
That no LED is blinking is normal on the other hand as HITL_USB wants
to run on a tiny2.11 where LEDs are connected at different locations.
Can you "tail /var/log/messages" and see if you get a message about a
new usb device when you power your board with USB plugged in ?



On Sat, May 22, 2010 at 12:46 PM, Eric Parsonage
<address@hidden> wrote:
> Hey all, particularly booz-ers
> Thanks to Antoine, I was recently able to get my hands on a set of
> booz boards. I haven't got a platform to put them on yet, so I thought
> I would try some HITL, Antoine's code was still in the board so they
> booted up and the LEDs flashed away. I then tried to upload the
> HITL_USB aircraft to the board (yeah, I realise this was the wrong
> thing to do) so I reboot the board and it has clearly written
> something as I get no LED, and no response from it either. I have now
> tried to get the Booz2_a1 airborne code back onto it, and I get to the
> end of the build and it starts up the ISP, but is unable to write to
> the board. Is it possible that I could have blanked the USB boot
> loader? If so what do I need to do to get the boot loader back on with
> the booz? If not, is there something I have missed, since the system
> outputs the same whether or not the board is plugged in, even though
> dmesg still tells me whether its attached or unattached.
> Regards and thanks,
> Eric
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden

reply via email to

[Prev in Thread] Current Thread [Next in Thread]