I had a plane fall from the sky the other when I switched into AUTO1
mode and couldn't switch back out.. in AUTO1 it threw all the control
surfaces to their extreme ends (elevator down, ailerons right, rudder
right) and the plane locked up and nose-dived. I suspect my problem
might be related to my thermopile sensors not being correctly aligned
(the wiki is pretty vague on
it..), but I still can't figure out why
manual control didn't restore after I switched back..
On Fri, Apr 15, 2011 at 4:24 AM, GARCIA ALVAREZ, ANA
> Hi Roman,
> I have had the same problems you are relating. My RC link frequency was
> 35Mhz. I have recently moved to 2.4GHz and apparently I have no “automatic”
> mode switch.
> As to the GPS, I had accuracy problems related to the fact that my 2.4GHz
> modem was close to the GPS receiver.
> Paparazzi-devel mailing list
Paparazzi-devel mailing listaddress@hiddenhttp://lists.nongnu.org/mailman/listinfo/paparazzi-devel