|
From: | Gerard Toonstra |
Subject: | Re: [Paparazzi-devel] weird issue servo 5 on lisa/m2 |
Date: | Mon, 12 Nov 2012 14:07:31 -0300 |
Are you sure it is not making 400hz PWM? Most analog servo's can not cope with that and turn to one or the other extreme or vibrate like hell.
-Christophe
On Mon, Nov 12, 2012 at 3:16 PM, Gerard Toonstra <address@hidden> wrote:
_______________________________________________Hi all,
I'm using the Lisa/M2 and my airframe has motor, rudder, elevator and two ailerons.
I'm using ppm on UART1_RX, an analog airspeed sensor on ADC1.
I'm currently in the process of testing the actuators and configuring trims.
All actuators on 1-4 are working. The one on servo 5 outputs something entirely
incorrect. The servo moves to the extreme minimum and stalls.
I've attempted to use servo6 as well (which is no="5" in airframe file?), but this also
doesn't help and produces similar output.
Is there anything I need to specify in the airframe to get the output to work correctly?
( I'm aware of the servo7/8 define, but this is 5/6). I've looked at the code for ADC,
but couldn't figure it out if there was an issue with timers there. I just disabled the airspeed
sensor and DC cam, but this didn't help either. Any hints are welcome.
Rgds,
Gerard
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
[Prev in Thread] | Current Thread | [Next in Thread] |