[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH builder.git] master.cfg: add GNU poke builder
From: |
Arsen Arsenović |
Subject: |
Re: [PATCH builder.git] master.cfg: add GNU poke builder |
Date: |
Sun, 20 Nov 2022 15:43:20 +0100 |
Hi,
"Frank Ch. Eigler" <fche@elastic.org> writes:
> Other builder.sourceware.org projects that use both check & distcheck
> import the two sets of configury/test results into separate bunsen
> testruns, so they can be separately tracked. See also:
This is confusing me a bit. I tried running distcheck locally, and the
test results from the distcheck build would be deleted as the last step
of distcheck. These are the commands I ran (obtained from master.cfg
just to be sure):
git clone https://git.savannah.gnu.org/git/poke.git
cd poke
sudo genlop -t gettext
./bootstrap
./configure --enable-maintainer-mode
make V=1 -j 17
make -j17 V=1 check
make -j17 V=1 distcheck
There's no resulting .log anywhere that ``find .'' could reach.
I tried working around this by setting am__post_remove_distdir, but
that'd get inherited by the distcleancheck step and break it. I'm not
aware of a way to pass variables to just the top level make invocation.
Thanks.
--
Arsen Arsenović
signature.asc
Description: PGP signature
Re: [PATCH builder.git] master.cfg: add GNU poke builder, Mark Wielaard, 2022/11/23
- Re: [PATCH builder.git] master.cfg: add GNU poke builder, Jose E. Marchesi, 2022/11/23
- Re: [PATCH builder.git] master.cfg: add GNU poke builder, Mark Wielaard, 2022/11/23
- Re: [PATCH builder.git] master.cfg: add GNU poke builder, Mohammad-Reza Nabipoor, 2022/11/23
- Re: [PATCH builder.git] master.cfg: add GNU poke builder, Mark Wielaard, 2022/11/24
- Re: [PATCH builder.git] master.cfg: add GNU poke builder, Frank Ch. Eigler, 2022/11/28
- Re: [PATCH builder.git] master.cfg: add GNU poke builder, Arsen Arsenović, 2022/11/28