|
From: | Steffen Hausmann |
Subject: | problem with the installation |
Date: | Fri, 1 Dec 2000 21:30:53 +0100 |
Hi,
my grub doesn't boot proberly. each time when stage2 should be loaded there occures a 'GRUB read error'. i've two harddrives an older 6 GB one with windows on it and a new 30 GB one with windows and after it linux on it. i put the stage2 to file on the older 6 GB disk. then i installed grub by the following commands: embed (hd0,0)/grub/fat_stage_1_5 (hd0) [result 14] install (hd0,0)/grub/stage1 (hd0) (hd0)1+14/boot/stage2 what might be interesting is that if i try to start linux by typing kernel (hd1,5)/vmlinuz root=/dev/hdb8 there is an error message: Error 18: Selected cylinder exceeds maximumsupported by BIOS, but if i repeat the command there is no message at all and it i type boot the system is getting up correct. what can i do that grub can load the stage2 fi e from my harddrive? MfG Steffen Hausmann |
[Prev in Thread] | Current Thread | [Next in Thread] |