Dear all,
I have downloaded and built the GNU radio source code release 3.0 (Minimal
Build) on cygwin. The installation went without any error. But when i tryied to
run the sample dial_tone.py, i didnt get any error but at the same time there
was no dial tone sound at the output. So i checked that the "WAVE" source was
enabled in the audio control panel as instructed, but still no output
came.
Earlier when i was installing the wxpython
module as stated in the page
all the steps went well, but when i tried to run
the demo.py as indicated in the 13th step, I didnt get the output and no error
was reported. I feel these two issues have a link and hence i tried the steps
once again, but then got the same problem again.....No Output and No error...
Where could the problem be??
Solution to this problem could be very very
helpful.
Thanks