I've had quite a few problems which I think are caused by poor phase
noise on the XCVR2450 -- it's an all in one chip with a local oscillator
on board etc - the 2400 appears quite a bit better (20dB if I remember
correctly!)
The schematics are in an odd place for this board - I could only find a
link under the USRP1 page
http://gnuradio.org/trac/attachment/wiki/USRP/xcvr2450_rev1.1.pdf
Tim
On Tue, Oct 27, 2009 at 6:41 AM, N. Pelin Yalcin <address@hidden
<mailto:address@hidden>> wrote:
Dear All,
I would like to learn the noise floor of a receiver which uses USRP,
XCVR2450 and VERT2450.
Namely, when usrp_fft.py is run with no incoming signal present in
an indoor environment, what is the expected noise level?
Thanks in advance.
Regards,
Pelin Yalcin
Research Assistant
Center for Wireless Communications and Signal Processing Research
(CWCSPR)
New Jersey Institute of Technology
_______________________________________________
Discuss-gnuradio mailing list
address@hidden <mailto:address@hidden>
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
------------------------------------------------------------------------
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio