Re: [Discuss-gnuradio] gcc 4.5 and GNU Radio 3.3.0

[Thomas Spuhler]

On Thursday, November 04, 2010 02:35:32 pm Tom Rondeau wrote:
> On Thu, Nov 4, 2010 at 5:06 PM, Eric Blossom <address@hidden> wrote:
> > On Thu, Nov 04, 2010 at 10:17:04AM -0700, Steve Mcmahon wrote:
> >> It took me a while to get some time to go back to my openSUSE 11.3
> >> machine and regenerate the error message. Sorry, I should have done
> >> this when I made the initial post.
> >> 
> >> So I successfully installed the following from source under openSUSE
> >> 11.3:
> >> 
> >> Cheetah-2.4.2.1.tar.gz
> >> Markdown-2.0.3.tar.gz
> >> cppunit-1.12.1.tar.gz
> >> fftw-3.2.2.tar.gz
> >> gsl-1.14.tar.gz
> >> numpy-1.4.1.tar.gz
> >> sdcc-2.9.0-i386-unknown-linux2.5.tar.bz2
> >> swig-1.3.40.tar.gz
> >> 
> >> Then I do a "./configure" for GNU Radio 3.3.0, and it runs fine, and it
> >> reports it's going to build everything that I need/that it should.
> > 
> >> However, when I do a "make", it runs for a while, but then I get these 
errors:
> > There's a much easier way to get where you're headed.
> > 
> > Use the "master" branch in git.  I'm pretty sure it has this problem
> > fixed.
> > 
> >  http://www.gnuradio.org/redmine/wiki/gnuradio/Download
> > 
> > Eric
> 
> I just tried compiling from maint, master, and next on a new OpenSUSE
> 11.3 installation and all three compiled fine. It fails from the
> tarball for GNU Radio 3.3.0.
> 
> So use one of the git versions for now. If you're on a machine not
> connected, just git clone gnuradio (master is probably the best branch
> to use) and tar it up to move it across to the other computer. That
> should work for you.
> 
> When we get 3.3.1 out, this problem will be fixed.
> 
> Tom
> 
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
There is a patch for GCC4.5. I found it on Fedore. let me know if you ned it
-- 
Thomas