[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Signal Decay with USRP N210 Using BasicRX
|
From: |
Josh Blum |
|
Subject: |
Re: [Discuss-gnuradio] Signal Decay with USRP N210 Using BasicRX |
|
Date: |
Wed, 21 Sep 2011 12:24:50 -0700 |
|
User-agent: |
Mozilla/5.0 (X11; U; Linux x86_64; en-US; rv:1.9.2.21) Gecko/20110831 Lightning/1.0b2 Thunderbird/3.1.13 |
On 09/21/2011 12:18 PM, valentac wrote:
>
> So I've been doing some development and my USRP using a custom RF front end
> via the BasicRX daughter board and have noticed an RC decay. I thought this
> was my system, but I recently just put a signal generator directly into the
> USRP and noticed the same thing (although not as high of a time constant).
> My high frequencies are passing through fine (sharp transitions are
> present), but when a level is held at a positive or negative voltage, it
> decays to zero.
>
> Is there a limitation on the USRP or BasicRX card? Or something else I'm
> missing?
Yes, the basic boards cannot pass DC (and low frequency). You will want
an LFRX for that. -josh