|
From: | Marcus D. Leech |
Subject: | Re: Confusion about 'ports' |
Date: | Wed, 16 Mar 2022 18:48:11 -0400 |
User-agent: | Mozilla/5.0 (X11; Linux x86_64; rv:91.0) Gecko/20100101 Thunderbird/91.5.0 |
A side note. NEVER wire a transmitter directly to a receiver. Use a 30-40dB attenuator in-line. Because receivers that are intended for off-air (antenna-connected) signals areMarcus:
That did it! Thanks much.
I was definitely confused about being able to use both TX/RX and RX2 on subdev B to receive two signals. When I was doing that, I was thinking 'B:0' was sufficient--same device. But switching the antenna back to A, RX2 (as in the original two-block configuration) and using 'A:0 B:0' worked, so then I switched back and tried 'B:0 B:0' but that doesn't work.
Now I also understand (a little bit better anyway) the documentation
I appreciate your patience and skill Marcus,
C
[Prev in Thread] | Current Thread | [Next in Thread] |