[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [O] Comment lines interfere with figure options
From: |
Nicolas Goaziou |
Subject: |
Re: [O] Comment lines interfere with figure options |
Date: |
Fri, 30 Oct 2015 14:56:18 +0100 |
Hello,
Mark Edgington <address@hidden> writes:
> If I have some org-mode content that looks like this...
>
> #+NAME: fig-myimage
> #+CAPTION: Caption of Figure
> #+ATTR_LaTeX: :width 5cm
> #+RESULTS: myimage
> [[file:images/myimage.png]]
>
> then I get a centered figure with the appropriate width and caption
> when exporting to LaTeX. If, however, I add a comment (or two)
> in-between one of the option-lines...
>
> #+NAME: fig-myimage
> #+CAPTION: Caption of Figure
> # (this was the original width)
> # +ATTR_LaTeX: width 10cm
> #+ATTR_LaTeX: :width 5cm
> #+RESULTS: myimage
> [[file:images/myimage.png]]
>
> then all of the settings above the comments are lost. Would it be
> difficult to modify org-mode so that comment-lines are ignored when
> looking for a block of settings lines that precede an image?
It means introducing a special cases for comments (i.e.,
comments-in-attributes). I'm not a big fan of special cases.
However you can comment the attribute above the block, e.g.,
# (this was the original width)
# +ATTR_LaTeX: width 10cm
#+NAME: fig-myimage
#+CAPTION: Caption of Figure
#+ATTR_LaTeX: :width 5cm
#+RESULTS: myimage
[[file:images/myimage.png]]
It is very easy to do with M-S-up/down, considering you probably don't
have a screenful of attributes for the same block.
Regards,
--
Nicolas Goaziou