[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
\bar and measurePosition
From: |
Han-Wen Nienhuys |
Subject: |
\bar and measurePosition |
Date: |
Sat, 16 Jun 2001 11:12:20 +0200 |
address@hidden writes:
> The only way round I could find was to specify timing #f and reset
> measurePosition to 0 at each \bar.
>
> Am I going about this the wrong way? Surely when you do a manual \bar
> the measurePosition ought to be set to 0?
No. Various bars (|:, ||) can happen in mid-measure.
Quickest hack that I can think of: use time sig 20/4 , and reset the
measure with a barcheck when you need it. Ignore the plentiful warnings.
--
Han-Wen Nienhuys | address@hidden | http://www.cs.uu.nl/~hanwen/