Re: \bar and measurePosition

[Mats Bengtsson]

> address@hidden writes:
> > The only way round I could find was to specify timing #f and reset
> > measurePosition to 0 at each \bar. 
> > 
> > Am I going about this the wrong way? Surely when you do a manual \bar
> > the measurePosition ought to be set to 0? 
> 
> No. Various bars (|:, ||) can happen in mid-measure.
> 
> Quickest hack that I can think of: use time sig 20/4 , and reset the
> measure with a barcheck when you need it. Ignore the plentiful warnings.

Doesn't \cadenzaOn solve the problem in a clean way?
Note that Lilypond will only consider line breaks at bar lines. 

   /Mats