Re: doc help: 11.2.1

[Mats Bengtsson]

Sorry I should read more carefully.
I had only corrected the table, not the example on the top that you 
point out. I'll fix it in a minute or so.

Regarding \line {...}, you are right that a literal translation of
#:line( ...) corresponds to \line {...}, but there is no need to
write out the \line command since {...} is equivalent to \line {...}.
I'll add a note in "8.1.7 Overview of ...".

  /Mats

Mats Bengtsson wrote:
> I have already corrected this in the CVS some days ago!
>
>    /Mats
>
> Graham Percival wrote:
>
> > According to the docs, these two expressions are the same:
> > (markup #:column (#:line (#:bold #:italic "hello" #:raise 0.4 "world")
> >                   #:bigger #:line ("foo" "bar" "baz")))
> >
> > \markup \column < { \bold \italic "hello" \raise #0.4 "world" }
> >                   \bigger { foo bar baz } >
> >
> > Shouldn't the lilypond code be this instead:
> > \markup \column { \line { \bold \italic "hello" \raise #0.4 "world" }
> >                   \line {\bigger { foo bar baz } }
> >
> > ie didn't \column change away from being \column < >  ?
> >
> >
> > I also wonder about the Lilypond  { ... }  that's in the middle of the
> > table below that example -- again, shouldn't that be \line { ... }  ?
> >
> > Cheers,
> > - Graham
> >
> >
> >
> > _______________________________________________
> > lilypond-devel mailing list
> > address@hidden
> > http://lists.gnu.org/mailman/listinfo/lilypond-devel

--
=============================================
        Mats Bengtsson
        Signal Processing
        Signals, Sensors and Systems
        Royal Institute of Technology
        SE-100 44  STOCKHOLM
        Sweden
        Phone: (+46) 8 790 8463                         
        Fax:   (+46) 8 790 7260
        Email: address@hidden
        WWW: http://www.s3.kth.se/~mabe
=============================================